Подключение цифровой камеры Canon A70 0

Установлен ASPLinux 9.2. (Ядро 2.4.20-9.asp). По USB подключаем цифровую камеру Canon A70. Камера не опознаётся.

Детали

В ядре включены опции:

General setup —>

• Support for hot-pluggable devices

• Probe all LUNs on each SCSI device

Device Drivers —> USB support

<*> Support for Host-side USB

SCSI support —>

<*> SCSI support

<*> SCSI disk support

<*> SCSI generic support

USB support —>

<*> Support for USB

<*> Preliminary USB device filesystem

<*> UHCI (Intel PIIX4, VIA, …) support

<*> USB Mass Storage support

По команде dmesg имеем:

hda: Maxtor 6Y080L0, ATA DISK drive

hdb: Maxtor 4D040H2, ATA DISK drive

hdc: TEAC CD-W552E, ATAPI CD/DVD-ROM drive

ide0 at 0×1f0-0×1f7,0×3f6 on irq 14

ide1 at 0×170-0×177,0×376 on irq 15

hda: host protected area => 1

hda: 160086528 sectors (81964 MB) w/2048KiB Cache, CHS=9964/255/63

hdb: host protected area => 1

hdb: 80043264 sectors (40982 MB) w/2048KiB Cache, CHS=4982/255/63

Partition check:

hda: hda1 hda2 hda3 < hda5 hda6 hda7 hda8 >

hdb: hdb1 hdb2

SCSI subsystem driver Revision: 1.00

kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2

kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2

es1371: version v0.32 time 16:22:16 Feb 21 2005

Linux Kernel Card Services 3.1.22

options: [pci] [cardbus] [pm]

usb.c: registered new driver usbdevfs

usb.c: registered new driver hub

uhci.c: USB Universal Host Controller Interface driver v1.1

usb.c: registered new driver usbscanner

scanner.c: 0.4.9:USB Scanner Driver

usb.c: registered new driver dc2xx

dc2xx.c: v1.0.0:USB Camera Driver for Kodak DC-2xx series cameras

usb.c: registered new driver microtekX6

microtek.c: v0.4.4:Microtek Scanmaker X6 USB scanner driver

Initializing USB Mass Storage driver…

usb.c: registered new driver usb-storage

USB Mass Storage support registered

Вводим команду:

mount -t vfat /dev/sda1 /mnt/camera

Получаем:

mount: /dev/sda1 is not valid block device

Почему невозможно обратиться к устройству /dev/sda1 несмотря на включение драйверов SCSI в ядро?

Подскажите в чём дело и что делать? Заранее благодарен.